Home > Hp Officejet > Hp Officejet 6500 Error Code 344

Hp Officejet 6500 Error Code 344

If in a surge protector, remove it and use a wall outlet.Another suggestion I have would be to contact your fax line provider and see if they can detect any problems Learn How to Post and More  Community News  Best of the Community Blog  Notebooks Notebook Operating System and Recovery  Notebook Boot and Lockup  Notebook Wireless and Networking  Notebook Audio  Notebook Video, When sendinga fax,the message on the front panel shows connecting. Best of luck!Errors 344-346Can't Send or Receive FaxesFax Product on a PBX, ISDK, or DSL Phone System Don't forgot to say thanks by giving "Kudos" to those that help solve your have a peek here

Have DSL8. Support Forum Join the conversation! Question about LaserJet 3050 All-In-One Printer 1 Answer Fax error 344 - HP officejet 4255 all-in-one ...error 344 - HP officejet 4255 all-in-one I have had the same problem fax error Ask the remote user to reconfigure the sending fax machine to send using a standard (letter or A4) page width. 281 282 ECM 283 284 285 ECM 286 290 The telephone http://support.hp.com/us-en/document/buu02549

Plan to connect printer to a different telephone line (number) and try faxing to determine if there is a line issue or a problem with the printer. First Time Here? Subsequent page transmission can still occur and later pages can be received without error.

or it's affiliates. replied5 years ago. Make sure you phone cord is plugged directly into the wall and into the line port of your printer. Resend the document as a normal fax, rather than attempting a BFT transfer. 320 The local machine is set to initiate poll reception with a remote machine, but detected that the

The remote user pressed the Stop key while the reception was in progress. Retry the fax transmission when the line is no longer busy. 314 The local machine attempted to initiate a remote diagnostic session, but detected that remote diagnostics are disabled on the On many fax machines, it is possible to accidentally initiate a fax reception in the following cases: There is no paper in the machine. If the problem persists there may be a problem with the printer.

XXXXX XXXXX [emailprotected]XXX-XXX-XXXX Share this conversation Expert: Handy--Andy replied4 years ago. Ask Your Own Printers Question Customer: replied5 years ago. The user at the remote machine might have pressed the Stop key. Wait several minutes between the end of one transmission and the start of the next transmission. 383 ECM Disable ECM, and then try faxing again.

  1. How does HP install software and gather data?
  2. The remote user pressed the Stop key while the reception was in progress.
  3. Z7_M0I02JG0KONJ30ACBBF8MM1084 hp-hero-support-search Actions ${title} Loading...
  4. Showing results for  Search instead for  Do you mean  or Post new question Post new question Question Reply Topic Options Subscribe Mark Topic as New Mark Topic as Read Float this
  5. Have you tried sending a fax to a different ricepient to see if the problem persists.Also the article I linked mentioned, the problem can be related to the receiving machine being

Find Solutions, ask questions, and share advice with other HP product owners. Still says Fax Send Report is set to Off. I found very little on the internet except that this is a hardware issue.What do I do? Do not have DSL or PBX, but have Verizons FIOS cable modem [M1424WR] that bundles internet, television and telephone.After re-reading my post, what are your thoughts.

The printer/phone cord are plugged in properly. navigate here These errors can occur if the phone lines in the area to be faxed are old or there is noise (static on the phone line). The reason for the communication errors is because of the static noise interference over digital lines. Reply 0 0 DaisyCat1 Honor Student Posts: 3 Member Since: ‎04-16-2012 Message 3 of 10 (1,960 Views) Report Inappropriate Content Re: Officejet 6500 Faxing Problem Options Mark as New Bookmark Subscribe

No distinctive ring. 2-wire cable used. Select a slower reception speed. Interpreting fax send error codes This table contains fax send error codes. Check This Out Disable ECM, and then try to receive the fax again.

If the session fails after sending several pages of a large document, resend the document as several smaller documents. Reply 0 Reply 0 0 DexterM Regents Professor Posts: 4,502 Member Since: ‎11-17-2008 Message 2 of 4 (4,906 Views) Report Inappropriate Content Re: Officejet 6500 wireless E709n FAX error Options Mark Don't forgot to say thanks by giving "Kudos" to those that help solve your problems.When a solution is found please mark the post that solves your issue.

It worked like a charm!!

Enable the BFT capability on the remote machine if supported. But I did hold the # XXXXX 3 keys as you said, and I didn't let go of them until the home screen appeared. Please follow the steps below.Step 1: Alter Error Correction Mode: On the front panel of your printer touch the Setup buttonTouch Fax SetupTouch Advanced Fax SetupSelect Error Correction ModeTurn Error Correction Expert: Sowrav D.

Remote diagnostics cannot occur between machines with incompatible remote versions. 316 The local machine is set to initiate document transmission, but detected that the remote machine is not able to receive Call the telephone provider if line conditions fail to improve. All rights reserved. this contact form Click here for instructions on enabling and disabling ECM (c00060802) (in English).

Showing results for  Search instead for  Do you mean  or Post new question Post new question Question Reply Topic Options Subscribe Mark Topic as New Mark Topic as Read Float this Z7_3054ICK0KGTE30AQO5O3KA30N0 hp-concentra-wrapper-portlet Actions ${title} Loading... AnswerManCharles and 2 other Printers Specialists are ready to help you Ask your own question now Customer: replied4 years ago.