Home > Hp Officejet > Hp Deskjet 460 Error Messages

Hp Deskjet 460 Error Messages

Contents

Solutions Follow these solutions in the order presented to clear the paper jam. OR Figure 5: The Resume light blinks, the Right Cartridge light blinks, and the Power light is on The Resume light blinks, the Right Cartridge light blinks, and the Power light Place the product back in its normal position.Step two: Reset the product CAUTION: Do not reset the product if the ink service module is not replaced. Cause There is an issue with the ink service module. have a peek at this web-site

Close the cover on the product. If the cartridge is outside of the product for too long, the ink can dry and clog the nozzles. If possible, unplugged all USB devices except the printer - at least for testing. Trying to clear jammed paper from the front of the product can damage the print mechanism.

Hp Officejet H470 Ink Service Module

The self-test report prints. The following light pattern displays on the product control panel: Resume light: Cycle Left Cartridge light: Cycle Right Cartridge light: Cycle Power light: Cycle Figure 3: The Power light, Resume light, If the carriage is stuck in the middle of the product, move the carriage to the right side of the product.

  1. The self-test report prints.
  2. This should take only a few seconds.
  3. I never once bought a new ink discard reservoir.
  4. Make sure that the carriage can move freely across the width of the product.
  5. Clean the cartridge contacts with the damp swab.

Disconnect the power cord from the back of the product. Figure : Open the cover on the product Lift the cartridge cover, and then gently pull the black cartridge up and out of the slot. The product is processing Digital Print Order Format (DPOF) printing. Hp Deskjet 460 Printer Manual If the issue persists, continue with the next solution.

Solution four: Service the printer If you have completed all the steps listed above and are still experiencing a problem, continue to the Service the printer section at the end of Hp Officejet H470 Ink Service Module Reset If the issue persists, continue to the next solution. caution: If the paper tears when you remove it from the rollers, check the rollers and wheels for torn pieces of paper that might remain inside the product. http://support.hp.com/us-en/document/c00818130 Figure : Cartridge contacts Lightly moisten another swab with distilled water, and then squeeze any excess water from the swab.

Disconnect the power cord from the back of the product. Hp Officejet H470 Cartridge Stalled Wait for the Power button to quit blinking and stay lit. If the issue persists, continue with the next solution. Check for any paper or object that might be restricting the carriage.

Hp Officejet H470 Ink Service Module Reset

Gather the following items: Clean distilled water. http://www.ehow.com/how_7161292_reset-hp-460-printer.html caution: Do not touch the ink nozzles. Hp Officejet H470 Ink Service Module I don't know which it has it has ink leaking out of the bottom of the printer.Thanks,Philip by unknown on Apr 3, 2011 at 8:12pm Add comment Please sign in to Hp Officejet H470 Reset Figure : Open the cover on the product Remove any jammed paper from the front of the product.

Grasp any jammed paper, and then pull the paper out towards you. http://domcached.com/hp-officejet/hp-officejet-pro-k850-error-messages.html If the issue persists, continue to the next solution. Press and hold the Power button (). The ink service module needs to be replaced as soon as possible. Hp Officejet H470 Troubleshooting

When the cartridge initialization completes, the carriage returns to the home position on the left side of the product. If the issue persists, continue to the next solution. Solution three: Repeat the reseating and cleaning steps If the problem is not solved, repeat the reseating and cleaning procedures above. http://domcached.com/hp-officejet/hp-officejet-g85-error-messages.html Figure 42: Remove the tape Reinsert the cartridges into the empty carriage slots at the same angle you removed them, and then close the cartridge cover.

Figure 50: Insert the new cartridges Close the cartridge covers on both carriage slots to secure the cartridges into place. Hp Officejet H470 Resume And Power Light Blinking The self-test report prints. Press and hold the Power button ().

Solution four: Replace the problem cartridge Use the following steps in the order presented to replace the black cartridge and align the cartridges.

If so, allow the carriage to move to that position. Add to Want to watch this again later? Support Forum Join the conversation! Hp Officejet H470 Blinking Orange Light Close the cover on the product.

Solutions Use the following solutions to resolve the issue. Make sure that the paper tray contains paper. Did the page print? http://domcached.com/hp-officejet/hp-j6400-error-messages.html Grasp any jammed paper, and then pull the paper out towards you.

caution: Only remove or install cartridges when the carriage stops moving. If the issue persists, continue to the next solution. Close the cartridge cover to secure the cartridge into place. Figure 37: Insert the new cartridge Close the cartridge cover to secure the cartridge into place.

Press the Power button () to turn the product on. The system returned: (22) Invalid argument The remote host or network may be down. Figure : Insert the paper and adjust the paper width guide Press the Resume button () to continue the print job. NOTE: Printing in Reserve Mode might affect the color results and the print speed.

I have the HP 470 and I had the "ink service module full" warning come up. Figure 45: Cartridge contacts Lightly moisten another swab with distilled water, and then squeeze any excess water from the swab. The product is printing. Plug the power cord back into the wall outlet.

As someone mentioned above, the part numbers for the spittoon are different but your approach should get me to where I am going. Disabling other firewalls/Antivirus Software If the computer uses other firewall programs (such as Zone Alarm, Black ICE, or others), consult the documentation that came with the firewall to help in disabling Check for any paper or object that might be restricting the carriage. caution: Do not remove jammed paper at this stage.