Home > Hp Laserjet > Hp Laserjet 4200 Errors

Hp Laserjet 4200 Errors


It causes static electricity, which can, in turn, cause paper jams. Action Press the ? (Help) button for detailed information. Make sure that the tray is fully inserted into the printer and is not overfilled. top Additional information To print a configuration page at the control panel Press (Select) to open the menus. Source

Flex the arms on the plastic output bin slightly to remove one side of the tray at a time. Press the (Up Arrow) and (Down Arrow) buttons to step through the instructions and/or refer to the following steps. top 10.XX.YY SUPPLIES MEMORY ERROR Description The printer is unable to read the electronic information (e-label) on the print cartridge so that the printer can keep track of the page count top 55.X PRINTER ERROR For help press ? http://h20564.www2.hp.com/hpsc/doc/public/display?docId=emr_na-bpl12422

Hp Laserjet 4250 Error 13.20.00 Jam In Tray 2

alternates with 64 PRINTER ERROR To continue turn off then on 66.00.15 EXTERNAL DEVICE FAILURE 66.12.XX OUTPUT DEVICE FAILURE For help press? 68.X PERMANENT STORAGE ERROR For help press ? This product has been successfully added to your profile. Reinstall the stapler/stacker or stacker. If the printer is already plugged into a wall outlet, try another power source in the building that is independent of the one currently being used.

Figure 40: Inserting fuser Install the rear output bin. Open the trays, remove the paper, and remove the obstruction. Action Press the (Select) button to continue. Hp Laserjet 4250 Error Codes top 13.10.00 FUSER JAM Description A paper jam exists in the fuser area.

Turn the power off. Lonnie Ernst 30,530 views 10:00 how to repair hp laserjet 5200 and 5200n paper jam fix - Duration: 6:55. Close Yeah, keep it Undo Close This video is unavailable. http://h20565.www2.hp.com/hpsc/doc/public/display?sp4ts.oid=85754&docId=emr_na-c00633921&docLocale=en_US Leave a little bit excess length on the aluminium strip to tape the foil to the cartridge, but not over the location of the copper tabs.

If this workaround is not acceptable or the error message persists after performing all of the recommended actions, contact an authorized HP Service or Support Provider: http://www.hp.com/go/support top 11.XX Internal Clock 13.20.00 Jam Inside Rear Door If the fuser does not click into place you run the risk of wearing out both the fuser and the gears that drive the fuser prematurely. While grasping onto both sides of the fuser, push the blue levers upward and pull the fuser straight out. Action Press (Select) to continue.

  1. The line voltage and current source at the printer location might need to be inspected to ensure that it meets the electrical specifications for the printer. (See the printer User's Guide
  2. The stapler/stacker LED blinks in amber.
  3. Scroll to the System Setup submenu, and then scroll to either CLEARABLE WARNINGS or AUTO CONTINUE.
  4. Figure 19: Reinstalling the print cartridge and closing the top cover If a jam message persists, jammed paper is still jammed in the printer.
  5. Transcript The interactive transcript could not be loaded.
  6. To view Help for a message (if available), press (Help).
  7. alternates with 51.XY PRINTER ERROR To continue turn off then on 52.XY PRINTER ERROR For help press?

Hp Laserjet 4250 Error 13.01.00 Jam In Tray 2

Remove any jammed paper from the stapler/stacker. http://www.printertechs.com/printer-troubleshooting/11-50-2-fuser-error Depot International Tech Support 11,689 views 1:20 RM1-1082 hp 4250 4350 Fuser film sleeve how to rebuild - Duration: 12:29. Hp Laserjet 4250 Error 13.20.00 Jam In Tray 2 Sign in 12 Loading... Hp Laserjet 4200 Error Codes Figure 46: Pulling the cover on the right side of the printer Remove the cover from the printer.

CAUTION: Do not fan the paper. this contact form The ON setting determines that the clearable warning message appears until (Select) is pressed. You might damage the fuser. If the above action does not solve the issue, contact HP or authorized service provider. 13.20.00 Jam In Tray 2 Hp 4015

Sign in to add this video to a playlist. NOTE: Avoid spilling loose toner. Press the (Up Arrow) and (Down Arrow) buttons to step through the instructions. have a peek here This cleans up the permanent storage by removing old areas that are not being used.

Description The paper that is loaded in the tray is longer or shorter than the size that is configured for the tray. Hp Laserjet 4200 Cartridge Installed Message Push the fuser firmly--listen for the sound of both blue levers clicking into place. top 52.XY PRINTER ERROR For help press?

alternates with 59.XY PRINTER ERROR To continue turn off then on Description A temporary printing error occurred.

If the above action does not solve the issue, contact HP or authorized service provider. Figure 34: Turning off and unplugging the printer Turn the printer so that its rear cover faces you. Please go to Hewlett Packard Enterprise Support Center. Hp Laserjet 4200 And 4300 Series Printers Drivers top 50.4 FUSER ERROR Description The problem exists with the customer’s line voltage.

Privacy Policy Terms of Use ERROR The requested URL could not be retrieved The following error was encountered while trying to retrieve the URL: Connection to failed. If the message persists, contact HP Customer Support. If the above action does not solve the issue, contact HP or an authorized service provider. Check This Out Figure 16: Opening Tray 1 and removing entrance cover Rotate the paper guide to check for additional jammed paper underneath.

HP 4200 4250 4300 4350 Series Printer (Refurbished HP printers http://www.ValstarPrinters.com) Upon clearing jam and still receiving this error messages, this fix will clear it up in most instances. Types of messages Status messages Status messages reflect the current state of the printer. Action NOTE: Press the ? (Help) button for detailed information about clearing the jam. Please try the request again.

top 8X.YYYY EIO ERROR Description The EIO accessory in slot [X] has encountered a critical error. [X] description: 1 = EIO slot 1 - The printer detected an error with the If a jam message persists, it is possible that paper is still jammed in the printer. compu85 6,077 views 4:51 HP 4200 4250 4300 4350 13.20 error on startup fix - Duration: 1:44. top top 13.01, 13.03 JAM IN TRAY (X) Description Paper jam in one of the trays/open and close top cover.

Look for the jam in another location, contact HP, or contact an authorized service provider. Figure 52: Setting bottom of cover onto the printer Slide the cover toward the front of the printer until it clicks into place. No more paper jams!