Home > Hp Laserjet > Hp Laserjet 3380 Help

Hp Laserjet 3380 Help

Contents

At the bottom of the formatter, disconnect the FFC (callout 1). Change the media to a lower basis weight. Very low humidity can increase the amount of background shading. Figure 5-55. http://domcached.com/hp-laserjet/hp-laserjet-3380-troubleshooting.html

Remove the printer top cover (see Printer top cover). 2. Replace the fuser. Lift off the solenoid. Page 123: Adf Document-feed Guide/cleanout Comb 4. http://h20564.www2.hp.com/portal/site/hpsc/public/psi/manualsResults?sp4ts.oid=378060

Hp Laserjet 3380 Driver

To maintain quality, thoroughly clean the product when these conditions exist: ● any time a new print cartridge is installed ● after printing approximately 2,500 pages ●... ECU loads Figure 4-6. Check the appropriate component and replace if necessary.

  • Light/Dark Def.
  • Remove one screw (callout 1), lift out the plastic ADF scanner-glass frame, and then lift out the glass.
  • The product could not be added to your profile at this time.

Remove the right-side cover and the back cover (see Printer right-side cover Back cover). Fax controls Use the fax controls to send and receive faxes. The other is used primarily in European countries/regions. Hp Laserjet 3380 All-in-one Printer Price Gently shake the print cartridge back and forth to redistribute the toner.

Find by product name or number (e.g. Hp Laserjet 3380 Driver For Windows 7 32bit Remove the back cover (1 of 2) The back cover has two tabs (not shown): one on the side of the printer, and one on the bottom Note of the printer. HP LaserJet 3380 all-in-one physical specifications..........7 Table 1-2. http://h20564.www2.hp.com/portal/site/hpsc/public/psi/troubleshootResults?sp4ts.oid=378060 Do not bend or fold the FFCs during the removal or reinstallation process.

Replacing the printer separation pad (9 of 9) If the pad is not properly positioned, the product might be noisy or the media might not feed at Note all. Hp Laserjet 3380 Specs These controls and the fax menu or software are used to change commonly used fax settings. Remove some of the sheets. Gently thread the solenoid cable through the hole (callout 4) in the right-side plate. 6.

Hp Laserjet 3380 Driver For Windows 7 32bit

Page 86 The timing diagram in Figure 4-2. http://h20564.www2.hp.com/portal/site/hpsc/public/psi/setupInstallResults?sp4ts.oid=378060 Page 131: Scanner Pca 3. Hp Laserjet 3380 Driver Page 78: Replacing An Adf Pickup-roller Assembly 3. Hp Laserjet 3380 Toner Page 68: Cleaning The Print-cartridge Area Note This process requires using a transparency to remove dust and toner from the print paper path.

The flatbed has no minimum size specification, and accepts a maximum size of legal-size media (215.9 mm by 355.6 mm, or 8.5 inches by 14 inches). this contact form If the problem persists, reset the BIOS settings in CMOS. Plug the product directly into an AC outlet. In the Paper tab of the driver, under Type is:, select the appropriate media type from the drop-down list. Hp Laserjet 3380 Manual

Figure 5-34. Page 109 The product also has scan-ahead functionality that makes use of flash memory. Scanner/printer separation not required: ADF pickup-roller assembly ADF document-feed guide/cleanout comb ADF separation pad height guides transfer roller ADF lid ADF scanner glass and frame control-panel bezel... have a peek here Rotate the green lever until it stops in the open position.

Patch management Diagnostic passwords Software updates & licensing Top issues Most viewed solutions Other solution options Troubleshoot a problem Community forums Advisories, bulletins & notices Choose your manual type or view Hp Laserjet 3380 Scanner Error Replacing the pickup roller (8 of 9) 9. Remove the left bottom frame support 4.

The paper was damaged by inconsistent manufacturing processes.

Remove the ECU pan (5 of 5) shows the two fuses on the ECU. If you need to Note realign the 69T gear, you must first remove the pressure-roller gear. Remove the front guide assembly (2 of 3) 4. Hp Laserjet 3380 Scanner Not Setup On Pc Page 3 LaserJet 3380 all-in-one Service Manual...

Figure 3-36. Page 180 Does the product receive a fax? Your cache administrator is webmaster. http://domcached.com/hp-laserjet/hp-laserjet-4-error-57.html Figure 5-50.

Replacing the pickup roller (9 of 9) Replacing the printer separation pad If the input tray feeds more than one sheet at a time, try cleaning the separation pad. If you have an active Support Agreement or HP Care Pack, you can link them to your profile to ensure access to all services. Page 48 Table 2-1. To check for proper installation, lift the green lever until it remains in the open position.

Page 53: Labels Problems with feeding. customers should call the local HP Sales and Service office or visit the http://www.hp.com/recycle website for further information regarding availability of the HP Supplies Returns and Recycling program. Remove the control-panel chassis (2 of 2) Reinstallation tip The speaker and control-panel cable are both replaceable parts. Page 132 2.

From the time To compensate for variability in Calibration is performed by the copy/scan/fax button is the scanning system. Make sure that the media meets specifications detailed in the HP LaserJet Printer Family Media Guide. Figure 3-2. Page 159 3.

This dc hold circuit is the main component of the voltage-current characteristic between TIP and RING. HP LaserJet 3380 all-in-one performance specifications (continued) Item Value Printer minimum paper size 76 by 127 mm (3 by 5 inches) Printer maximum paper size 216 by 356 mm (8.5 by The following table lists approximate schedules for replacing consumables. Remove the solenoid (2 of 2) Reinstallation tip If you have trouble rerouting the cables through the hole (callout 2) in the right-side plate, remove the ECU pan (see ECU fuses

Plug the product in, and then use the power switch to turn on the product.