Home > Hp Deskjet > Hp Deskjet 5550 Mechanism Error

Hp Deskjet 5550 Mechanism Error

Contents

Rotate the rollers as you clean them to make sure they are clean all the way around. Find Solutions, ask questions, and share advice with other HP product owners. If these steps resolved the issue, you do not need to continue troubleshooting. When I replaced the top cover, I wedged the top cover operator into the closed (down) position as a work-around solution while I report these actions to you for further suggestions. http://domcached.com/hp-deskjet/hp-deskjet-3820-mechanism-error.html

Raise the cartridge latch. After installing a new cartridge, the product automatically calibrates the cartridges and prints an alignment page. Release both buttons at the same time. Figure : Remove the cartridge caution: Do not touch the copper-colored contacts or the ink nozzles.

Hp Deskjet 5550 Blinking Ink Light

Figure 89: Do not touch the contacts or the ink nozzles Step two: Reinsert the cartridge Hold the cartridge so that the nozzles face down and the contacts face toward the Disconnect the power cord from the printer. 2. Reach inside the product, and then manually move the carriage.

  • Close the duplexer door.
  • Figure 103: The Black Cartridge Low-ink icon Image: The Black Cartridge Low-ink icon Cause The black cartridge is low on ink.
  • Remove the new cartridge from its package, and then carefully remove the protective tape.
  • If the light continues to blink after several seconds, continue to the next solution.
  • Solution three: Make sure that the carriage moves freely, and then print a self-test report Use the following steps to make sure that the carriage moves freely, and then print a
  • Lift the top cover.
  • Close the duplexer door.
  • Problem with HP Photosmart C3180 All-In-One InkJet Printer.
  • note: If the product prints when plugged directly into a wall outlet, the power strip or surge suppressor might not be allowing enough voltage to reach the product.

Solution three: Load paper The product might be out of paper. If the issue persists, continue with the next solution. I would certainly appreciate any expertise help you might have to offer.Rick FarrarDavie, Florida - Anonymous 0 Before following Stephen's detailled directions for removing the printer covers, I again tried to Hp Deskjet 5550 Not Printing Figure 78: Close the cartridge latch Close the top cover.

If the product connects to a power strip, check the switch on the power strip to make sure that it is turned on. Hp Deskjet 5550 Troubleshooting Remove the rear access door. Any suggestions? http://h20564.www2.hp.com/hpsc/doc/public/display?docId=c00035263 Make sure that the power cord is connected to the wall outlet.

note: Do not press the buttons on the sides of the duplexer when reattaching it to the product or it might not snap securely into place. How To Free Cartridge Cradle On Hp Printer I had exactly this problem, or rather, my parents had, and of course they called me (300 miles away) to fix the problem over the phone.Thanks a million for posting your Press the buttons on the sides of the duplexer at the same time, and then pull the duplexer toward you to remove it. Figure 50: Paper feed rollers Locate the paper pick roller.

Hp Deskjet 5550 Troubleshooting

what can i do? have a peek at this web-site Plug the power cord back into the wall outlet. Hp Deskjet 5550 Blinking Ink Light Reattach the duplexer. Cartridge Cradle Cannot Move Solution Hp How to print a self-test page Load plain, white paper into the input tray.

Now my printer works just fine thanks to your expertise. Check This Out Contacting HP for service in all countries/regions except Asia Pacific. Figure : Open the duplexer door Carefully remove any jammed paper or bits of torn paper from the rollers inside the duplexer. Figure 47: Clean the paper pick roller Allow the rollers to dry for 10 to 15 minutes. Hp 5550 Print Cartridge Status Light Is Flashing

If one or both of the cartridges are missing, continue to the next step. Wait until the carriage stops moving and is silent before proceeding. So to reset remove your printer from the PC and uninstall the printer ... Source NOTE: If the product prints when plugged directly into a wall outlet, the power strip or surge suppressor might not be allowing enough voltage to reach the product.

NOTE: Use a flashlight to thoroughly check the rollers and wheels for torn pieces of paper that might remain inside the product. Hp Printer Cartridge Stuck Right Side Apply a moderate amount of pressure to remove any dust or dirt buildup. Touching these parts can result in clogs, ink failure, and bad electrical connections.

by Stephen on Apr 17, 2007 at 11:19am Add comment Please sign in to comment Thank You Stephen.

IMPORTANT: Remove the paper very carefully. Figure : Reattach the rear access door Step three: Clear the paper jam from the front of the printer If you cannot remove the paper jam from the back of the Raise the cartridge latch. The Print Carriage Cannot Move Hp Envy 4500 by unknown on Jun 1, 2007 at 8:40pm Add comment Please sign in to comment 0 5550 cartridges are easy to refill, I get Stratitec kits at Sam's Club.You can find

Remove the rear access door. Figure : Raise the cartridge latch Push down on the cartridge to release it, and then pull the cartridge toward you to remove it from its slot. Gather the following materials: A clean, lint-free cloth, or any cloth that will not come apart or leave fibers Distilled, filtered, or bottled water (tap water might damage the product) A http://domcached.com/hp-deskjet/hp-deskjet-5550-error.html Disconnect the power cord from any power strips or surge suppressors, and then plug it directly into a wall outlet.

If the product does not turn on by itself, press the Power button () to turn it on. If any torn pieces of paper remain inside the product, more jams are likely to occur. Turn the door latch counter-clockwise, and then pull the door away from the product to remove it. Step one: Remove the cartridge Press the Power button () to turn on the product.

What can I do? If these steps resolved the issue, you do not need to continue troubleshooting. Figure : Remove the protective tape from the cartridge Hold the cartridge so that the nozzles face down and the contacts face toward the carriage. If the test page does not print, continue with the next solution.

Follow these steps to check the condition of the paper. If this roller is not clean, more paper feed issues are likely to occur. Figure : Remove the cartridge Step two: Insert a new cartridge Follow these steps to insert a new cartridge. Using a screwdriver or similar tool, push the capping station toward the back of the printer.

Blinking Lights on the HP Deskjet 5550 Printer Series Blinking lights The lights on the front of the HP product can be on, off, or blinking (flashing), depending on the status Slide the cartridge at a slight upward angle into the empty slot, and then gently push it forward until it snaps into place. Store the paper in a dry, cool place. Press the Power button () to turn on the product.

The green and orange lights keep flashing together and the printer wont work. After the carriage stops in the center pull the power plug. This light pattern can be caused by at least one other component, but the paper motion will be different.To start the diagnosis I tried to print a demo page, to do Figure 15: Move the paper width guide inward Move the paper length guide inward until it rests against the edge of the paper.

With the product turned on, disconnect the power cord from the rear of the product. by Anonymous on Jan 2, 2009 at 6:31pm Add comment Please sign in to comment 0 I have a similar but different problem.