Turn the door latch counter-clockwise, and then pull the door toward you to remove it. Solution two: Determine the cartridge issue When there is an issue with a cartridge, a yellow arrow on top of the carriage (inside the product) points to a drawing of a Make sure that the carriage can move freely across the width of the product by gently pushing the carriage to the left and then to the right. thanks so much!! have a peek at this web-site
Solution one: Wait for the print job to complete Wait for the product to finish processing the print job. note: Make sure to clean the paper pick roller thoroughly. The carriage might move to the center of the product. The info below is taken directly from the Color Laserjet 5500 service manual which is essentially the the same as the 5550.
Hp Deskjet 5550 Blinking Ink Light
If the issue persists, continue with the next solution. If this roller is not clean, more paper feed issues are likely to occur. First Time Here?
Solution five: Service the printer If you have completed all the solutions listed above and are still experiencing a problem, continue to the Service the printer section at the end of
Figure 49: Remove the duplexer Lightly dampen a clean, lint-free cloth with bottled or distilled water, and then squeeze any excess liquid from the cloth.
Figure 53: Reattach the duplexer Press the button on top of the duplexer, and then open the duplexer door.
I installed the new cartridge, closed the lid, turned off the printer and unplugged the cables.
Press the cloth against the paper feed rollers and then rotate them upward with your fingers.
Close the duplexer door.
Figure 106: Remove the protective tape from the cartridge Hold the cartridge so that the nozzles face down and the contacts face toward the carriage.
How to print a self-test report Make sure that plain white paper is loaded in the input tray.
Figure : Close the cartridge latch Close the top cover.
The self-test report prints. Solution three: Reset the printer Press the Power button () to turn on the product. With the product turned on, disconnect the power cord from the rear of the product. Hp Deskjet 5550 Troubleshooting Guide Press and hold the Power button ().
Figure 90: Insert the cartridge Close the cartridge latch. Hp Deskjet 5550 Manual works fine from my older pc, but the new pc just spits out a blank sheet of paper. by Stephen on Dec 13, 2006 at 9:01pm Add comment Please sign in to comment 0 Stephen, I have been struggling with this problem for the last 72 hours, reading your It makes all the normal clicking and whirring noises but the paper stays put.
The printer is a DeskJet 5550 with 22,839 pages through it - and still going strong. Hp Deskjet 5550 Reset Proffitt Forum moderator / July 18, 2009 7:20 AM PDT In reply to: HP DeskJet 5550 printer wont recognize new HP ink cartridge Why I ask is that many (I did It worked fine until Friday July 9th 2004 . A little water in a saucer works fine, you only want to wet the nozzles, keep the rest of the cartridge dry.
How to print a self-test report Make sure that plain white paper is loaded in the input tray. Reach inside the product, and then manually move the carriage. The carriage moves to the center of the product. http://domcached.com/hp-deskjet/hp-deskjet-5550-error.html Figure : Remove the cartridge Step two: Insert a new cartridge Follow these steps to insert a new cartridge.
From the Size is drop-down menu, select the paper size that matches the paper in the tray. Hp Deskjet 5550 All Lights Blinking How do I rethread it? Do not use paper that has previously been printed on.
I guess that my principal problem was probably the Top cover sensor operator?
Step one: Check for missing cartridges Open the top cover, and then check if one or both of the cartridges are missing. The product lights might flash and the carriage might move. If these steps resolved the issue, and the test page prints, there is no need to continue troubleshooting. Hp 5550 Deskjet Printer Troubleshooting Solution four: Adjust the print settings The product might not pick up paper if the paper size and type in the paper tray do not match the size and type settings
When I print the same document on plain paper, the rectangle does not appear. CAUTION: Do not remove jammed paper at this stage. This solved my same issue instantly. Remove the new cartridge from its package, and then carefully remove the protective tape.
Solution two: Clear any jammed paper Jammed paper can cause the carriage to stall. Step one: Remove the cartridge Press the Power button () to turn on the product. Go to HP SureSupply. If these steps resolved the issue, and the test page prints, there is no need to continue troubleshooting.
by unknown on Sep 11, 2005 at 5:02am Add comment Please sign in to comment 0 I am having a problem with my HP DeskJet 5550...it has worked great all this Color Laser Printer Image Quality Problems Blank Prints (No Error Code) ......................................................... 22 Blank Print (With Error Code) ....................................................... 23 Color Density Problems ................................................................. 24 Colors Misregistered (Color Plane Registration, CPR) He's not very computer savvy so I believe he just pulled out the paper from the front instead of the back. Figure 70: Determine the cartridge issue 1 - Tri-color Cartridge Problem icon 2 - Black Cartridge Problem icon 3 - Tri-color Cartridge Low-ink icon 4 - Black Cartridge Low-ink icon 5
Use both hands to pull out whole sheets of paper to avoid tearing them. If the test page does not print, continue with the next solution. The tri-color cartridge goes in the left carriage slot. All settings are for one copy.
Press the Power button () to turn on the product. Disconnect the power cord from the rear of the product.