Home > Fax Error > Hp Officejet 6500 Error 346

Hp Officejet 6500 Error 346

Contents

Make sure paper is loaded correctly, paper is not jammed within the machine, and any other system errors have been cleared. 232 233 234 235 ECM 236 ECM 237 A communication Fax quality might be degraded. Reply 0 0 Travis_C Regents Professor Posts: 4,871 Member Since: ‎11-22-2011 Message 8 of 10 (1,688 Views) Report Inappropriate Content Re: Officejet 6500 Faxing Problem Options Mark as New Bookmark Subscribe Set the host machine to receive at a slower transmission speed. Source

Resend the document as a normal fax, rather than attempting a BFT transfer. 320 The local machine is set to initiate poll reception with a remote machine, but detected that the In particular disabling the ECM and Fax Hardware Test-All Passed. If the local machine consistently gives this error code from different fax numbers, then the issue is probably hardware related and the machine should be replaced or serviced. These errors can occur if the phone lines in the area to be faxed are old or there is noise (static on the phone line).

Hp Fax Error 346

Reply 0 0 « Message Listing « Previous Topic Next Topic » Related Documents Testing Your HP Fax Machine with the HP Fax Test ServiceHP Printers - Network Scanner Connection is Call the telephone provider if line conditions fail to improve. 291 292 The received fax could not be stored. Confirm that the fax/phone cable is no longer than required, and that it does not pass near unshielded electric motors such as fans, heaters, or household appliances.

  • For example, the local machine wanted to initiate polling, but the remote machine did not support this mode of operation.
  • These errors can occur if the phone lines in the area to be faxed are old or there is noise (static on the phone line).
  • Reply 0 0 Everyone's Tags: AS1 View All (1) JimVincent Honor Student Posts: 2 Member Since: ‎01-10-2013 Message 3 of 3 (2,917 Views) Report Inappropriate Content Re: What is fax error
  • This might occur naturally depending on when the fax session is terminated.
  • Note the remote machine's number and any fax information.

Try the fax when telephone line conditions have improved. 440 441 442 443 444 An error occurred during transmission after one or more partial pages were sent. However, the LCD on the front of the machine continues to display "Connecting..."After less than a minute, the fax disconnects and prints a 344 error page.Any thoughts? The click, heard for an incoming call, is actually a momentary disconnect of the line.The remote user pressed the Stop key while the reception was in progress.Under rare conditions, incompatibility between Hp Fax Comm Error The fax used to work when I had Microsoft but now with Mac.....it goes so far and then times out.

The remote fax machine determined that there was a feature incompatibility between the two machines and terminated the session. Fax Error Codes Try to verify this by sending the same fax to other fax machines. Other reasons can include power outages and other power-related problems.'Solution:Retry the fax reception when telephone line conditions have improved. Confirm that the remote user has the correct password, and that the local machine is configured with the same password, if this option is available. 230 The remote machine attempted to

Set the host machine to receive at a slower transmission speed. Hp Fax Error 388 However, the ability to receive the entire document improves. This situation is usually due to extremely poor line conditions. Confirm that the remote fax machine is ready to receive a document, and then try sending the fax again. 313 A busy signal was detected each time the local machine attempted

Fax Error Codes

The click, heard for an incoming call, is actually a momentary disconnect of the line. navigate to these guys These errors can occur if the phone lines in the area to be faxed are old or there is noise (static on the phone line). Hp Fax Error 346 Learn How to Post and More  Community News  Best of the Community Blog  Notebooks Notebook Operating System and Recovery  Notebook Boot and Lockup  Notebook Wireless and Networking  Notebook Audio  Notebook Video, How To Disable Ecm On Hp Fax Machine Most likely the issue is with the individual location you are attempting to fax.

If in a surge protector, remove it and use a wall outlet.Another suggestion I have would be to contact your fax line provider and see if they can detect any problems this contact form If you get the same error even then I would suggest that you lower the fax speed. You can do this in the Advanced Fax Setup in the Setup menu of the printer. Ask the sender to remove the fax number from the diagnostic check. 227 The remote machine attempted to initiate a fax session at a speed and modulation that the local machine Hp Fax Error 344

Call the telephone provider if line conditions fail to improve. I was an HP employee.Kudos are appreciated if I have helped you. I can only test using the DSL filter I have (today).I have tried a few different numbers and the 344 error with same symptoms persists. have a peek here The remote (calling) fax machine determined that there was a feature incompatibility between the two machines.

The remote machine failed to respond to a fax command from the local machine because the connection was interrupted. Fax Error 350 Z7_3054ICK0KGTE30AQO5O3KA30H5 hp-country-locator-portlet Actions ${title} Loading... Videos English Open Menu English Deutsch Español Français Português 中文 한국어 † The opinions expressed above are the personal opinions of the authors, not of HP.

I read the fax, it dials the number and gets the fax tone, but when it tries to send it to the number, it times out after about 30 seconds.

Other reasons can include power outages and other power-related problems.*The call-waiting service can cause this error. By using this site, you accept the Terms of Use and Rules of Participation Discussion Boards Open Menu Discussion Boards Open Menu Welcome to the Forum! Confirm that the sender is not inadvertently attempting to poll the local machine for a document, instead of sending to the local machine. Fax Error 321 Enable ECM on both the local machine and the remote machine. 231 The remote machine attempted to initiate a transmission to the local machine, but the receive capability was disabled at

Try to send the fax using a different mode. Subsequent page transmission can still occur and later pages can be received without error. View Solution. http://domcached.com/fax-error/hp-officejet-6500-fax-error-351.html The second article is for further troubleshooting and the third article should help with faxing on DSL.

First Time Here? Make sure the remote machine can accept and use polling. There is nothing on my line! Call the telephone provider if line conditions fail to improve.Disable ECM.