Home > Fax Error > Hp Erro 388

Hp Erro 388

Contents

The noise may be on your end or on the other person's end. Privacy Policy © Copyright 2016 HP Development Company, L.P. Ideas? There was a communication error with the sending fax machine.

Any other suggestions? Retry the fax reception when telephone line conditions have improved. If you want remote polling, confirm that you have correctly configured the local machine for poll transmission. 229 The remote machine attempted to initiate a secure poll transmission from the local By using this site, you accept the Terms of Use and Rules of Participation Discussion Boards Open Menu Discussion Boards Open Menu Welcome to the Forum! https://h30434.www3.hp.com/t5/LaserJet-Printing/Fax-error-code-388-how-to-resolve/td-p/2339029

Hp Fax Error 344

Disable ECM. Confirm that the remote fax machine is ready to receive a document, and then try sending the fax again. 313 A busy signal was detected each time the local machine attempted Remove any pass-through devices from the phone line, and then try the fax again.

  1. HP technical support states this is an error resulting from too much noise on your telephone line, which interrupts your ability to send a fax.
  2. On many fax machines, it is possible to accidentally initiate a fax reception in the following cases: There is no paper in the machine.
  3. Retry the fax reception when telephone line conditions have improved.
  4. Submit Your Work!
  5. An error code can have more than one definition (cause), and more than one solution.
  6. Try sending the fax again. 312 A remote fax machine failed to answer the call.
  7. In V.34 mode, it is alsopossible for this error to occur because of compatibility problems with certain machines and/or line conditions.You can re-attempt the fax transmission at a different time when
  8. Reply 0 0 « Message Listing « Previous Topic Next Topic » Related Documents Testing Your HP Fax Machine with the HP Fax Test ServiceHP Printers - Network Scanner Connection is

I faxed over from a hp photosmart c6180 all in one series printer. Ask the community! The receiving fax machine is an older silent fax machine. Error 388 Hp Officejet 6700 However, the ability to send the entire document improves.

Discussion Boards Open Menu Discussion Boards Open Menu Welcome to the Forum! Hp Fax Error 345 This might occur naturally depending on when the fax session is terminated. Retry the fax reception when telephone line conditions have improved. https://h30434.www3.hp.com/t5/Scanning-Faxing-and-Copying/Error-388-appears-when-I-try-to-fax-Does-anyone-have-a/td-p/891381 Enable ECM on both the local machine and the remote machine. 231 The remote machine attempted to initiate a transmission to the local machine, but the receive capability was disabled at

Reply 0 0 « Message Listing « Previous Topic Next Topic » Related Documents Testing Your HP Fax Machine with the HP Fax Test ServiceHP Printers - Network Scanner Connection is Fax Error 350 Thedocumentcan be foundhere. Enable the remote diagnostics capability on the local machine, if available. Everything should pass.Turn ECM Off - Setup > Fax Menu > Advanced Fax Settings > Error Correction Mode > OffFax Speed - Setup > Fax Menu > Advanced Fax Settings >

Hp Fax Error 345

Call the telephone provider if line conditions fail to improve. 291 292 The received fax could not be stored. This is a common error when attempting to fax over VoIP, such as MagicJack. Hp Fax Error 344 Turn off all other electrical devices to check if the line noise is coming from something electrical in your home or office. Fax Error 388 Hp Officejet Call the telephone provider if line conditions fail to improve.http://support.hp.com/us-en/document/buu02549#Error247 Hope this helps.

HP officejet 4215 error 388* will not send fax will receive fax? It is possible that the remote user inadvertently attempted to poll. UteMtn Solved! Error Code(s) Definitions/Causes Solutions 386 387 388 389 390 391 392 393 394 395 There is too much noise on the line for a valid connection between two fax machines to Fax Error 346

Configure the remote machine for document reception by clearing any paper jams, loading sufficient paper, and clearing any other error messages. Note the remote machine's number and any fax information. Retry the fax reception when telephone line conditions have improved. I have a HP 8500a Plus all in one machine.

Only two-conductor phone cables should be used to connect the all-in-one to the phone line.Figure : The difference between a two-conductor phone cable and a four-conductor phone cableA two-conductor cableA four-conductor How To Turn Off Ecm On Hp Fax Machine Have the sender send from a different fax machine to see if the error clears. 242 The remote fax machine is attempting to receive instead of send. Normally I would recommend you contact your phone company, but you have said you already spoke with them before even posting.What you can do, is use the following link to create

The click, heard for an incoming call, is actually a momentary disconnect of the line.

Request a test on the line to check if the telephone provider should increase the signal ratio. I just tried your fix but it did not work for me. Select a slower reception speed. Error 388 Hp Officejet 4500 I will be happy to fix your problem ASAPThe fax error code 388,that you recieve while trying to send fax means Line disturbance or noise( http://h10025.www1.hp.com/ewfrf/wc/document?lc=en&dlc=en&cc=us&docname=buu02549#Error386 )Try to get a line

Disable ECM, and then try faxing again. 382 ECM The remote fax machine held the local fax machine from continuing the ongoing transmission because of a temporary low memory condition at Source(s): error 388 sending fax friend message error 388: https://tinyurl.im/6UpHd Thomasine · 1 year ago 0 Thumbs up 0 Thumbs down Comment Add a comment Submit · just now Report Abuse Ask IT Technicians for Answers ASAP Not a Printers Question? This situation is usually due to extremely poor line conditions.

When we settle the issue, I'd like for you to kindly mark the appropriate post as Accept as Solution so that others encountering the same or similar issue can find what In some cases this error can occur if the other fax machine is using a fax format incompatible with the HP fax. 422 423 A handshaking (connection) error occurred at some i get script error n it wont let me message them? Showing results for  Search instead for  Do you mean  or Post new question Post new question Question Reply Topic Options Subscribe Mark Topic as New Mark Topic as Read Float this

The local machine has originated a fax session and detected a remote fax machine but has been unable to detect any T30 frames. Can anyone give me a solution to this problem? This occurs during ECM transmission after trying repeatedly to send a fax. Error Code(s) Definitions/Causes Solutions 325 ECM 326 ECM 327 ECM 328 ECM Telephone line conditions were very poor.

If this holding period exceeds a machine’s specific timeout value, the session is terminated. Error Code(s) Definitions/Causes Solutions 300 The fax session completed without errors. This error is very rare because normally a remote machine does not answer if it cannot receive a document. Errors might still occur, and might result in a degraded image quality on the received page.

Any suggestion. Enable ECM. Disable ECM, and then try to receive the fax again. Reply 0 Fax error code 388 - how to resolve 01-22-2013 11:59 AM @UteMtnI would take a look at the document below it describes what every fax error code means.

Printer passes all internal tests. Thanks - I work on behalf of HP"HP respects and is committed to protecting the personal information of our covered individuals." You can read more in the HP Privacy Statment Reply Ask the remote machine user to send at a lower resolution setting. Video should be smaller than 600mb/5 minutes Photo should be smaller than 5mb Video should be smaller than 600mb/5 minutesPhoto should be smaller than 5mb Related Questions Trying to send 10-mb